Product added to cart
Fiberlock IAQ 6000 Mold Resistant Coating
$395.50
In stock
SKU
CHE2000
IAQ 6000 meets or surpasses recommended performance criteria in the IICRC S520 Mold Remediation Standard. Recommended for AIA/CSI 02 87 13 or 02 85 00 Mold Remediation architectural specifications.
White - 5 Gallon
IAQ 6000 is a white, tintable mold resistant coating*, that contains a fungistatic agent to resist mold growth on the dry coating surface. IAQ 6000 is a durable, flexible, and permeable 100% acrylic water based coating. IAQ 6000 is recommended for use on wood, plaster, wallboard, sheetrock, concrete, masonry block, primed metal and galvanized metal.
*Resistant to mold growth on the dry coating surface only
Features
- Tested by independent laboratories for mold resistance: ASTMG-21 and ASTM D-3273
- Mold resistant*
- Tintable formula
- 100% acrylic
| Brand | Fiberlock Technologies |
|---|---|
| Chemical Type | IAQ |
| Coating | Mold |
| Dilution | Ready-to-Use |
| Packed As | Pail |
| Container Type | 5 gallons |
Write Your Own Review
Surface Preparation
Surfaces to be coated must be free of dust, mildew, mold, dirt, grease, loose paint, oil, glue size, calcimine, wax, soap and other surface contamination. Clean mold stained surfaces with Advanced Peroxide Cleaner, or use an EPA registered antimicrobial disinfectant cleaner such as IAQ 2000, IAQ 2500, ShockWave or ShockWave RTU. Patch irregularities with vinyl patching paste or an appropriate patching compound. IAQ 6000 is self-priming over bare sheetrock, composition board, ceiling tile and concrete.
Wallboard, Sheetrock, Gypsum Board
Joint cement should be sanded smooth, but avoid abrading the paper.
Ferrous Metal
Clean, then prime with IAQ 4000 rust inhibiting direct-to-metal primer.
Wood
Seal knots and stains with IAQ 5000 stain-blocking primer.
Masonry Block
Apply one coat of IAQ 3000 block filler if a denser surface is desired.
Application Tools
Apply Fiberlock IAQ 6000 with brush, roller, or airless spray equipment. Refer to the product application section below for more specific information on settings and which tools to select.
Product Application
Air and surface temperature must be 50°F or above during application and drying period. Fiberlock IAQ 6000 is supplied ready to use, but can be thinned sparingly with water (up to 1/2 pint water per gallon) for proper application consistency if necessary. Apply Fiberlock IAQ 6000 generously and uniformly by brush, roller or airless sprayer. Ensure that the finished surface is properly sealed.
- Brush: Synthetic, nylon or polyester bristle
- Roller: Synthetic fiber 3/8”nap or longer
- Airless spray settings
- Pressure: 2000-3000 PSI
- Tips: .019 to .021 tips
Precautions
Stir thoroughly. Do not mix with any other coatings, solvents, or colors in oil. Fiberlock IAQ 6000 is resistant to the deteriorating action of mold, mildew, and bacteria. No claim is made for the preservative action to other than the coating film. Do not apply when air or surface temperature is below 50°F or when drying conditions are poor. Keep from freezing. Use adequate ventilation during application.
Clean Up
Clean tools and drippings with warm, soapy water before Fiberlock IAQ 6000 dries. Dispose of all waste according to all existing local, state, and federal regulations.
More from Fiberlock Technologies
