Novatek Vacuum Shrouded Needle Scalers 2B Pistol Grip

Placing Tool in Service

• Always install, operate, inspect and maintain this product in accordance with all applicable standards and regulations (local, state, country, federal, etc.).
• Compressed air models always use clean, dry air at 90 psi (6.2bar/620kPa) maximum air pressure at the inlet. Higher pressure may result in hazardous situations including excessive speed, rupture, or incorrect output torque or force.
• Electric models must always utilize proper gauge, and rated electrical cords with correct connections.
• Be sure all hoses and fittings are the correctly sized and secured.
• Ensure an accessible emergency shut off has been installed in the air or electrical supply line.  Make others aware of its location.
• Do not use damaged, frayed, or deteriorated air hoses and fittings.
• Always use proper gauge electrical cords with correct connections. (When applicable.)
• Electric models must not use damaged, frayed, or deteriorated electrical cords and connections.
• Keep clear of whipping air hoses. Shut off the compressed air before approaching a whipping hose.
• Always turn off and disconnect the tool from its power supply before installing, removing or adjusting any accessory, or before performing
  any maintenance on the tool.
• Do not lubricate tools with flammable or volatile liquids such as kerosene, diesel or jet fuel. Use only recommended lubricants.
• Keep work area clean, uncluttered, ventilated and illuminated.
• Keep all electrical connections clear of water or other liquids. (When applicable.)
• Do not operate the machine while flammable or volatile liquids such as gasoline, diesel or jet fuel are present. Failure to do so can result in
  explosion. (When applicable.)
• Do not remove any labels. Replace any damaged label.
  
  

Using The Tool

• Always wear protection when operating or performing maintenance on this tool.
• Always wear hearing protection when operating this tool.
• Always use Personal Protective Equipment appropriate to the tool used and material worked. This may include dust mask or other breathing apparatus, safety glasses, ear plugs, gloves, apron, safety shoes, hard hat and other equipment,
• Prevent exposure and breathing of harmful dust
  and particles created by power tool use:
• Some dust created by power sanding, sawing, and grinding, drilling, and other construction activities contains chemicals known to cause cancer, birth defects or other reproductive harm. Some examples of these chemicals are:
• - Lead from lead based paints, Crystalline silica from bricks and cement and other masonry products, and Arsenic and chromium from chemically treated lumber. Your risk from these exposures varies, depending on how often you do this type of work. To reduce your exposure to these chemicals: work in a well ventilated area, and work with approved safety equipment, such as those dust masks that are specially designed to filter out microscopic particles.
• Keep others a safe distance from your work area, or ensure they use appropriate Personal Protective Equipment.
• This tool is not designed for working in explosive environments, including those caused by fumes and dust, or near flammable materials.

Read all instructions and data in operation and maintenance manual prior to operation of  this equipment.
These instructions are for your protection and convenience. Please read them carefully since failure to follow the precautions could result in injury. Whenever using electric powered equipment, basic safety precautions should be followed.

Prior to use

1. Ensure that sufficient length of 3/8” diameter hose is available and compatible with the tool’s ¼” NPT air inlet.
2. Tighten all hose connection fittings and blow out the air hose to insure that all debris is purged from the supply line.
3. Put a few drops of lubricant in the air inlet of the tool on a daily basis prior to start up and shut down. (See recommended air tool lubricants)
4. Inspect the tool’s external parts, fittings and needle wear. CAUTION: Do not inspect the tool without first disconnecting the air supply!