Mastercraft Enviromaster C5 Compact HEPA Critical Filter Dry Vacuum
$950.00
In stock
SKU
VM0005
The Mastercraft Enviromaster C5 Compact HEPA Dry Vacuum is easy to carry and transport. It is suited for cleanup in small and confined areas. Great for your dry vacuum works.
- Enviromaster C5 is easy to carry and transport, this compact vacuum is suited for cleanup in small and confined areas.
- Enviromaster C5 utilizes a Sealed Critical HEPA (99.99% @ .1-.3 m) filter and ships complete with a disposable paper filter bag (5/Pk), Intermediate prefilter (2/Pk) and dry tool kit.
- Motor Head Equipped with 1.3 HP motor and fitted with a power nozzle receptacle. Includes 30ft, 3-wire grounded safety yellow power cord.
- HEPA Filter System Consists of a 14" Sealed Critical HEPA (99.99% @ .1-.3 m) filter, intermediary micro filter, and disposable filter bag. HOT DOP method certified.
- Vacuum Tank Rotationally molded, high-impact plastic with .25 wall construction. Equipped with four 2.5 swivel casters. The no-tip base design has a low center of gravity.
Whats Included
- 14" HEPA Filter
- 1.25" Straight Wand (qty: 2)
- 1.25" Crush Proof Vinyl Hose w/ Cuffs
- 1.25" Dry Tool Kits
- Filter Bags 2/pk
- 14" Intermediate Filter, 2PPK
Specifications
- Model: P4511HVAF-R
- Air Flow: 94 CFM
- Waterlift: 90"
- Max Current Draw: 6 Amps
- Recovery: .12bu
- Recovery Tank Capacity: 5 gal.
- Recovery Tank Type: Polyethylene
| Brand | Mastercraft |
|---|---|
| Air Filtration Tool Type | HEPA Dry Vacuum |
| Motor | 1.3 Hp |
| Water Lift | 90 Inch |
| Recovery | 12bu |
| Recovery Tank Capacity | 5 gal |
| Current | 6 Amp |
| Construction | Polyethylene Tank |
Write Your Own Review
Intended Use of the Vacuum:
- This vacuum has been specifically designed to clean up hazardous dust. Special filters reduce the incidence of airborne dust that would be created by other methods of cleaning.
- During the removal of hazardous dust, DO NOT sweep, scoop, shovel or in any manner handle other than by vacuuming.
- DO NOT at any time attempt to remove, substitute, bypass or by any other means change the filters in the vacuum.
- Use only manufacturer’s approved vacuum filters and filters bags.
- Before attempting to use or before cleaning with this vacuum, be sure that you fully understand the instructions for setting up or cleaning/changing filters.
Unpacking and Caster Installation
Remove the vacuum, hose and wand from the shipping carton. Disengage the clamps on the tank and carefully remove the motor head, filter assembly, tools and casters packed inside the vacuum tank. To install the casters, turn the tank upside down and press casters into the plastic sockets until bottom of stem fits flush against the plastic sockets.
Installation of Filters
The intermediate filter is a very fine nonwoven filter that extends the life of the expensive High-Efficiency Particulate Air (HEPA) filter.
- Disengage clamps that hold motor head to the tank. Carefully set aside.
- Remove HEPA filter and intermediate filter. Set aside.
- Install a new disposable paper filter bag by taking hold of the free ends of cardboard attached to the paper bag. Pull the cardboard forward over inlet fitting so that the cardboard is as close to the tank wall as possible.
- Place the intermediate filter in position on top of the tank. Fold the edge over the outside of tank, overlapping approximately one inch.
- Insert the HEPA filter, being careful not to move the intermediate filter. The filter’s sealing gasket must sit evenly on the tank rim so an air tight seal will be obtained.
- Replace motor head assembly on top of HEPA filter seated in the top of the tank.